any 1.6 with gt3071 here ?
#1
Junior Member
Thread Starter
iTrader: (1)
Join Date: Apr 2008
Location: Greece
Posts: 99
Total Cats: 0
any 1.6 with gt3071 here ?
Hi folks after some modifications to my car i am planning to go for tuning to my dyno.
I planning to boost 28-30 psi my engine and i want to have an idea for that i will may expect. So if is here anyone with 1.6 and good power just help me.
My current setup is
Je pistons.Carrillo rods,Arp studs,Cometic Gasket,
Garrett Gt3071, 3'' custom exhaust,
tubular manifold with external wg,
Precision ic 1/2" L x 8" H x 3 1/2" D
RX7 FC II tranny,
Vipec v44 Ecu,650 Sard injectors,innovate wideband,
I planning to boost 28-30 psi my engine and i want to have an idea for that i will may expect. So if is here anyone with 1.6 and good power just help me.
My current setup is
Je pistons.Carrillo rods,Arp studs,Cometic Gasket,
Garrett Gt3071, 3'' custom exhaust,
tubular manifold with external wg,
Precision ic 1/2" L x 8" H x 3 1/2" D
RX7 FC II tranny,
Vipec v44 Ecu,650 Sard injectors,innovate wideband,
#5
Junior Member
Thread Starter
iTrader: (1)
Join Date: Apr 2008
Location: Greece
Posts: 99
Total Cats: 0
ok
until today i had a simple manifold internal wg with smaller ic and smaller exhaust
i made 300hp to 18 psi my spool was very good and from 4000 rpm
3071 is 500rpm slower from 2560 but after is a beast.
i took 40hp at same pressure when i change from 2560 to 3071
until today i had a simple manifold internal wg with smaller ic and smaller exhaust
i made 300hp to 18 psi my spool was very good and from 4000 rpm
3071 is 500rpm slower from 2560 but after is a beast.
i took 40hp at same pressure when i change from 2560 to 3071
#16
Well, I hope that you are full of ****. Simply because it will make me feel better about swapping from a 1.6 to a 1.8.
In all honesty I hope that you can prove it, I think it would be fantastic if someone could show a 300HP 1.6 with decent spool. That didn't have an *** ton of expensive headwork.
In all honesty I hope that you can prove it, I think it would be fantastic if someone could show a 300HP 1.6 with decent spool. That didn't have an *** ton of expensive headwork.