Forged rods with arp2000.... $225

Reply Subscribe

Thread Tools

Search this Thread

12-26-2011, 10:01 AM

#21

falcon

Elite Member

iTrader: (13)

Join Date: Dec 2009

Posts: 2,499

Total Cats: 16

It will always make it a bit bigger. Check your clearances before and after.

12-26-2011, 10:11 AM

#22

kfrancis

Junior Member

Join Date: Dec 2011

Location: Crestview FL

Posts: 76

Total Cats: 0

Ok thanks. If I was to get it bored where would I get the right sized pistons?

12-26-2011, 06:37 PM

#23

mx594m

Junior Member

iTrader: (1)

Join Date: Dec 2010

Location: Knoxville, TN

Posts: 279

Total Cats: 3

http://www.jepistons.com/Catalogs/Automotive/Index.aspx

12-26-2011, 06:47 PM

#24

TurboTim

Elite Member

iTrader: (9)

Join Date: Jun 2006

Location: Chesterfield, NJ

Posts: 6,898

Total Cats: 399

http://www.wiseco.com/Catalogs/Sport...undaiMazda.pdf

Wiseco's chinese rod (a.k.a. K1) part number is listed with the pistons too.

12-28-2011, 02:35 PM

#25

Golferluke

Junior Member

Thread Starter

Join Date: Oct 2009

Location: Springfield, MO

Posts: 492

Total Cats: 3

Quote:

Originally Posted by kfrancis

If you get your block honed does that always bore out the cylinder?

It will always technically make it bigger by removing material, but not nearly as much as boring. Honing basically scuffs the surface while boring cuts away material to enlarge the hole. Most of the time you don't need a new piston size after honing.

12-28-2011, 05:32 PM

#26

Terez

Newb

Join Date: Apr 2011

Location: Valkeakoski/Tallinn

Posts: 7

Total Cats: 0

Basically these SGI are the same as eagle and CAT and so on..

There are only Pauter and Carillo left of the big companies, that do their own rods, as others come from these same suppliers to different brands..