hey guys im going to install rx7s4 460cc low impedance. im not sure which wire to solder in a resistor.Ive heard it doesn't matter but im still not sure.

 

You'd be better off selling them and buying the correct injector. Theres more to low z and high z injectors than the resistance.

 

i really need to install them and get the car moving.so if anyone could tell me it would be greatly appreciated.

 

i opened the harness and found that the 2 green and 2 yellows have no interference so im going to solder the resistors in those wires.

 

Theres current difference And voltage difference.

2x on getting the correct pnp injectors.

 

And signal differences.

 

There you go. All better now.

 

Can a Low independence injector even open with the quarter amp they will be getting if u just install a resistor to get them to 14 ohms? Doubt it and even if they do i betcha they will have a hell of a dwell curve.