Should I (naturally aspirated) install bigger injectors now?
#21
Junior Member
Thread Starter
iTrader: (-1)
Join Date: Nov 2013
Location: GA
Posts: 171
Total Cats: -156
QUICK QUESTION GUYS!!!
You're fine. If they are in good shape, then a reasonable price. If the rubber parts need replacement, then they can be found. Just wanting to be plain, and perhaps add some humor (sometimes difficult to convey via text).
I am running the same Inj with good results N/A with MS3. Turbo is not in yet, but build is in progress.
The particular route I went was to buy some in rough shape for $10 each and then add $22 each to have them cleaned, checked, and the bits replaced. Pretty much same total $$.
Easy to change out. Just watch the little rubber spaces that go between the rail mounting tabs and the mounting surface (head or intake manifold, I don't remember which). When you pull the bolts and move the rail, they can fall out.
I am running the same Inj with good results N/A with MS3. Turbo is not in yet, but build is in progress.
The particular route I went was to buy some in rough shape for $10 each and then add $22 each to have them cleaned, checked, and the bits replaced. Pretty much same total $$.
Easy to change out. Just watch the little rubber spaces that go between the rail mounting tabs and the mounting surface (head or intake manifold, I don't remember which). When you pull the bolts and move the rail, they can fall out.
Hey dudes i got the injectors in today and wow they look great, the picture did not do them justice. even the rubber o-rings are in good shape and i have a spare RX-8 fuel rail laying around. lol
Now to the important stuff.
What do i need to change in my engine constants.
i know i use the little calculator tool for the REQ-Fuel.
but what about the other options!! please respond im going to try and throw them in today!
#24
Retired Mech Design Engr
iTrader: (3)
Join Date: Jan 2013
Location: Seneca, SC
Posts: 5,009
Total Cats: 857
OK, well how do i change it?
don't know if you are running ms2 or somthing. I am running MS1/PNP.
here is a screen shot of my constants. Dont see anything about dead-time
Attachment 106997
don't know if you are running ms2 or somthing. I am running MS1/PNP.
here is a screen shot of my constants. Dont see anything about dead-time
Attachment 106997
Since these are High Impedance, I don't understand the PWM Limit and Time, but that is beyond my experience (Never had MS1)
Last edited by DNMakinson; 03-22-2014 at 04:18 PM. Reason: Removed un-necessary dig
Thread
Thread Starter
Forum
Replies
Last Post
stoves
Suspension, Brakes, Drivetrain
5
04-21-2016 03:00 PM