Miata Turbo Forum - Boost cars, acquire cats.
The wider aluminum tunnel still needs trimming and flanges.
The wider aluminum tunnel still needs trimming and flanges.
0 2016/03/11 20:19:49
0 2016/03/12 22:50:33
Check out the bump plot. So far the bearings just don't come into play.
Check out the bump plot. So far the bearings just don't come into play.
0 2016/03/14 21:15:23
0 2016/03/17 16:33:23
0 2016/03/17 19:15:11
0 2016/03/19 18:15:09
0 2016/03/19 18:15:16
0 2016/03/19 18:15:33
0 2016/03/19 18:15:54
0 2016/03/19 18:16:20
0 2016/03/19 18:16:30
There's a low pressure zone at the back of the hood that will draw a lot of air from the engine.
There's a low pressure zone at the back of the hood that will draw a lot of air from the engine.
0 2016/03/19 18:18:35
Right over the turbo...
Right over the turbo...
0 2016/03/19 18:18:45
0 2016/03/19 18:20:04
0 2016/03/19 18:20:10
0 2016/03/19 18:21:13
0 2016/03/19 18:21:18
0 2016/03/19 18:21:28
0 2016/03/19 18:21:38
0 2016/03/19 18:24:47
The slotted hole at the bottom allows fore/aft placement of the pedal. It bolts into the stock Miata gas pedal location.
The slotted hole at the bottom allows fore/aft placement of the pedal. It bolts into the stock Miata gas pedal location.
0 2016/03/19 18:26:36
Air inlet goes to a pocket under the cowl, complete with drainage tube. The air can be sent wherever it's wanted.
Air inlet goes to a pocket under the cowl, complete with drainage tube. The air can be sent wherever it's wanted.
0 2016/03/20 10:45:05
0 2016/03/27 18:21:28
0 2016/03/27 18:21:39
The new House Cat coolant reroute includes a swirl pot at the firewall.
The new House Cat coolant reroute includes a swirl pot at the firewall.
0 2016/03/27 18:23:48
This plumbing isn't finished, but shows the simple location of the coolant pipes. The 1.25" aluminum tube will be bolted down with a couple of P clips.
This plumbing isn't finished, but shows the simple location of the coolant pipes. The 1.25" aluminum tube will be bolted down with a couple of P clips.
0 2016/03/27 18:23:53
There's some good low pressure at the back of the hood.
There's some good low pressure at the back of the hood.
0 2016/03/27 18:30:23
The vent is right over the turbo, so radiated heat has a direct escape route when the car is off.
The vent is right over the turbo, so radiated heat has a direct escape route when the car is off.
0 2016/03/27 18:30:31
0 2016/03/28 11:11:01
0 2016/03/28 11:11:02
0 2016/03/28 11:11:04
0 2016/03/28 11:11:05
I predict that these ND's will end up on the track sooner than the NC's, simply because they're so capable.
I predict that these ND's will end up on the track sooner than the NC's, simply because they're so capable.
0 2016/04/03 12:29:23
Beautiful lines, perfectly proportioned IMO.
Beautiful lines, perfectly proportioned IMO.
0 2016/04/03 12:29:24
Look at that fit!
Look at that fit!
0 2016/04/03 12:29:25
High and tight, just like a Marine haircut. That means less Origami is needed to get into the car.
High and tight, just like a Marine haircut. That means less Origami is needed to get into the car.
0 2016/04/03 12:29:25
0 2016/04/04 20:02:05
0 2016/04/04 20:02:10
The big part stays under the bodywork, and the small splitter can be removed somewhat easily
The big part stays under the bodywork, and the small splitter can be removed somewhat easily
0 2016/04/04 20:03:12
0 2016/04/04 20:03:15