01 Coil-On-Problem.
#9
2 Props,3 Dildos,& 1 Cat
Thread Starter
iTrader: (8)
Join Date: Jun 2005
Location: Fake Virginia
Posts: 19,338
Total Cats: 573
i'd rather not sand **** if I dont have to. especially when i dont want to sand through insulation of indeterminate thickness.
but yah if you guys can get some measurements on those bad boys and your valve covers, that'd be greaaaaaaaaaaaaat.
but yah if you guys can get some measurements on those bad boys and your valve covers, that'd be greaaaaaaaaaaaaat.
#14
Boost Pope
iTrader: (8)
Join Date: Sep 2005
Location: Chicago. (The less-murder part.)
Posts: 33,027
Total Cats: 6,592
I had the same issue on my 1.6. Apparently some coils have those little rings while others don't.
Simple solution- spend a few minutes with a dremel and a carbide cutter to take off the rings.
Simple solution- spend a few minutes with a dremel and a carbide cutter to take off the rings.
#15
2 Props,3 Dildos,& 1 Cat
Thread Starter
iTrader: (8)
Join Date: Jun 2005
Location: Fake Virginia
Posts: 19,338
Total Cats: 573
Joe, I remember your post about that, but my rings are way thinner than yours. I'm not sure I could get the 20 thou plus clearance off that SOB. I can try though. It may be the bottom ring hanging up on the hole in the head.
for ref:
oh also for you 01+ guys, the flange at the top of the COP unit will run into the 01 coil mounting bosses. one has to go.
for ref:
oh also for you 01+ guys, the flange at the top of the COP unit will run into the 01 coil mounting bosses. one has to go.
#16
2 Props,3 Dildos,& 1 Cat
Thread Starter
iTrader: (8)
Join Date: Jun 2005
Location: Fake Virginia
Posts: 19,338
Total Cats: 573
GOOD NEWS EVERYONE.
The holes in the head are significantly larger than the holes in the valve cover. like 3/16 in diameter. so that's good. I can probably bore out the VC slightly with no problems.
The holes in the head are significantly larger than the holes in the valve cover. like 3/16 in diameter. so that's good. I can probably bore out the VC slightly with no problems.
#19
2 Props,3 Dildos,& 1 Cat
Thread Starter
iTrader: (8)
Join Date: Jun 2005
Location: Fake Virginia
Posts: 19,338
Total Cats: 573
AlO2 jim hat and a clean copy of Swank. BAM.
I suspect Ark's suggestion is probably reasonable. Or if you have a 1" drill bit you can do it that way--no doubt it's faster. hmm.
I suspect Ark's suggestion is probably reasonable. Or if you have a 1" drill bit you can do it that way--no doubt it's faster. hmm.