Are all knock sensors melted?
03-26-2018, 11:07 PM
#22
Junior Member
Join Date: Nov 2016
Location: Chicago
Posts: 496
Total Cats: -8
Need help with wiring the knock sensor into MS3 for NA chassis.
I see that I can either use 12 pin connector 2 or an options connector to bring the signal from the KS to the MS.
If using the connector 2 the pin is 2F - where do I wire the sensor ground to? Do I use options connector pin A for that?
Thanks
I see that I can either use 12 pin connector 2 or an options connector to bring the signal from the KS to the MS.
If using the connector 2 the pin is 2F - where do I wire the sensor ground to? Do I use options connector pin A for that?
Thanks
Reply
0
0
Thread
Thread Starter
Forum
Replies
Last Post
big jim
General Miata Chat
6
02-14-2010 06:03 PM
