Dual Port Wastegate
#4
Typically you connect the vacuum line from the wga to the boost controller. With a dual port, do you connect both lines to the same boost controller? with like a tee or something?
#5
Former Vendor
iTrader: (31)
Join Date: Nov 2006
Location: Sunnyvale, CA
Posts: 15,442
Total Cats: 2,099
You would tee a single feed line, and then put the MBC inline with the top port. The bottom port gets fed full pressure. The top port sees an additional 6psi from the MBC, suddenly your boost pressure is WG spring + 6psi, etc.
Or you get an EBC and hook it up as directed, and the EBC alternates between top and bottom like a good hooker.
Or you get an EBC and hook it up as directed, and the EBC alternates between top and bottom like a good hooker.
Thread
Thread Starter
Forum
Replies
Last Post
stoves
Suspension, Brakes, Drivetrain
5
04-21-2016 03:00 PM