94 1.8 ecu in NB?
#1
Junior Member
Thread Starter
Join Date: Nov 2006
Location: Santa Clarita, CA
Posts: 254
Total Cats: 0
94 1.8 ecu in NB?
i was kinda curious, i've heard of people doing this but havent really seen anything on it, but i bought this CAS from a 1.8 that i was gonna use for megasquirt but i ditched the idea and decided to go EMU, and then i was thinking would i be able to swap in a 94 ECU? with the cas and maybe switching some wires around on my harness. i want to go turbo, i already have a gt28r an hks manifold, turbo xs BOV, and custom piping, i was wondering if i'd be able to get away with using an older 1.8 ecu to adjust my timing, while i get the final peices in for my turbo. would i get any gains by doing this? i've heard OBDI would be alot easier to tune on my car. well i'm open to any suggestions or comments
#5
Junior Member
Thread Starter
Join Date: Nov 2006
Location: Santa Clarita, CA
Posts: 254
Total Cats: 0
cjernigan, i might have lean on you like a crutch so i can figure out this whole MS deal, i have to do the miata mods on the MS, and then i would need an iat and a cas wired to it, but it's the wiring i haven't been able to figure out, i guess i've been waiting around from something more comprehensive on MS
#6
mkturbo.com
iTrader: (24)
Join Date: May 2006
Location: Charleston SC
Posts: 15,177
Total Cats: 1,681
cjernigan, i might have lean on you like a crutch so i can figure out this whole MS deal, i have to do the miata mods on the MS, and then i would need an iat and a cas wired to it, but it's the wiring i haven't been able to figure out, i guess i've been waiting around from something more comprehensive on MS
#7
Junior Member
Thread Starter
Join Date: Nov 2006
Location: Santa Clarita, CA
Posts: 254
Total Cats: 0
i really like this forum, as long as you don't bring up something already stickied, everyone is really helpful
#9
Junior Member
Thread Starter
Join Date: Nov 2006
Location: Santa Clarita, CA
Posts: 254
Total Cats: 0
so all i really need to get up and running is the cas? if possible can i get them? and i'm sure they won't differ at all or much in 2000. i might just ride on your coat tails to success on this one. lol
#10
Yeah just the CAS and within a week or two i should have a msq that you could load and run off of to get started no problem. 2000 wire colors should be the same. Might want to check madracki though.
Here's the wire colors I have, if you need them in a different format than excel let me know.
Here's the wire colors I have, if you need them in a different format than excel let me know.
Thread
Thread Starter
Forum
Replies
Last Post
bigmackloud
Miata parts for sale/trade
19
01-08-2021 11:24 AM
JesseTheNoob
DIY Turbo Discussion
15
09-30-2015 02:44 PM