Notices
General Miata Chat A place to talk about anything Miata

Low oil pressure - coolant and oil mixture in radiator

Thread Tools
 
Search this Thread
 
Old Aug 23, 2024 | 01:43 PM
  #1  
Franznieto's Avatar
Thread Starter
Newb
 
Joined: Aug 2024
Posts: 1
Total Cats: 0
Default Low oil pressure - coolant and oil mixture in radiator

Hello! I have the following problem and I wanted to know if anyone in this chat has had a similar experience. I have a 93 miata with an engine swap to a 2001-2005 vvt 1.8. The engine is rebuilt. Block, rods, pistons, water pump, oil, alternator, sensors and an Ms3pro computer. Manual transmission. After about 200 miles of driving (in 2 months) I started to hear a rattling noise when decelerating or when downshifting. I also noticed that the oil pressure gauge needle would drop to zero at those times. Immediately upon accelerating it would go back up and normalize. The engine did not lose power or try to shut off. The last day I used it. it started to get hot and overheated, when I turned it off and checked it I found that the coolant bottle had a lot of oil. There is apparently no coolant or water in the engine mixed with the oil that made me doubt that it is the cylinder head gasket. (maybe) has anyone had a similar problem? any comments or suggestions on what the damage could be? I appreciate any help.
Old Aug 23, 2024 | 02:13 PM
  #2  
rjacobs's Avatar
Junior Member
 
Joined: Jul 2022
Posts: 164
Total Cats: 22
Default

Either head gasket or cracked block or head.
Old Aug 24, 2024 | 03:57 PM
  #3  
sixshooter's Avatar
Moderator
iTrader: (12)
 
Joined: Nov 2008
Posts: 22,204
Total Cats: 3,560
From: Tampa, Florida
Default

Oil warmer, head, block, headgasket, turbo.
Old Aug 26, 2024 | 04:54 PM
  #4  
Z_WAAAAAZ's Avatar
Elite Member
iTrader: (2)
 
Joined: Jun 2022
Posts: 2,461
Total Cats: 567
From: Aliso Viejo, CA
Default

What were the head studs (or bolts) torqued to?
Old Aug 26, 2024 | 06:45 PM
  #5  
sixshooter's Avatar
Moderator
iTrader: (12)
 
Joined: Nov 2008
Posts: 22,204
Total Cats: 3,560
From: Tampa, Florida
Default

Originally Posted by Z_WAAAAAZ
What were the head studs (or bolts) torqued to?
Good question
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
Kalashnikyle
Engine Performance
6
Feb 23, 2024 10:57 AM
redursidae
Engine Performance
10
May 16, 2023 10:36 PM
Rallas
Engine Performance
2
Nov 30, 2020 09:19 PM
lyonnate23
Engine Performance
20
May 12, 2019 11:51 AM
elior77
DIY Turbo Discussion
74
Feb 19, 2013 02:05 PM




All times are GMT -4. The time now is 06:56 PM.