Need water line banjo fitting for Garrett turbo
#1
Junior Member
Thread Starter
iTrader: (1)
Join Date: Jun 2008
Location: Atlanta, GA
Posts: 157
Total Cats: 0
Need water line banjo fitting for Garrett turbo
Anybody in Atlanta know where I could get one preferably same-day? The PO wasn't careful about routing lines and the braided oil line rubbed a pinhole in the line under the turbine.
He also didn't replace the rear main seal when he replaced the clutch. I found out where my quart per 500 miles was going!
He also didn't replace the rear main seal when he replaced the clutch. I found out where my quart per 500 miles was going!
#4
Used the typical spots, utilized hardline to AN adapters. I did a write up of it on here: https://www.miataturbo.net/forum/showthread.php?t=23366
Thread
Thread Starter
Forum
Replies
Last Post
Frank_and_Beans
Supercharger Discussion
13
09-12-2016 08:17 PM