Projectors in turn signals. A shitty DIY guide.
#145
Aidan do you think these are also crap as FF75? - My Hella Lights :: Optilux 2020 Dual Beam Driving/Fog Lamp Kit
#152
I got the LED blinkers wired but the flasher does not see them and is in the fast mode. The motorcycle turn signals all have 2 wires while our cars use a 3 wire socket relying on the dual filament bulb.
It works but does anyone know if I can wire this for a slow normal blink?
Solved - flasher mod had been done to allow for non hyper blink
The fix: Use the article in the garage to locate, remove, and open the flasher unit. With the components facing you and the pins pointing down, find the left relay. To its left is a 5.6K ohm resistor marked R1. Desolder this resistor and replace it with a 1Meg ohm resistor. Now reinstall everything and enjoy.
It works but does anyone know if I can wire this for a slow normal blink?
Solved - flasher mod had been done to allow for non hyper blink
The fix: Use the article in the garage to locate, remove, and open the flasher unit. With the components facing you and the pins pointing down, find the left relay. To its left is a 5.6K ohm resistor marked R1. Desolder this resistor and replace it with a 1Meg ohm resistor. Now reinstall everything and enjoy.
Last edited by stevos555; 06-24-2018 at 09:22 AM.
Thread
Thread Starter
Forum
Replies
Last Post
thumpetto007
General Miata Chat
4
02-23-2018 12:18 AM