Shift Light?
 

I have been looking into shift lights today, after hitting the rev limiter again

I have looked on our favorite supplier's site (Ebay ;) )
and have spotted a few


http://cgi.ebay.ca/ADJUSTABLE-RPM-BL...QQcmdZViewItem

And all time fav Glow Shift.

http://cgi.ebay.ca/PERFORMANCE-ADJUS...QQcmdZViewItem

And the plug into lighter type ???

http://cgi.ebay.ca/PURE-BLUE-LED-SHI...QQcmdZViewItem

As well as Raptor

http://www.raptorperformance.com/

Gizzmo

http://www.modyourcar.com.au/gizzmo-...iftlight-p5323



AutoMeter & MSD are not my favorites

Any suggestions?

Um...what?

Soooo, you hit the rev limiter and now want an annoying light to blink at you? You've done it twice...total. Hitting the rev-limiter won't do a whole lot to the engine, bouncing continuously off the rev limiter might. but a simple blip on the rev limiter isn't detrimental to anything.

Though I look forward to being on MS and potentially running on the spark cut limiter.

idk if the megasquirt can do it but when i had an FM LINK it had an option to use the check engine light as a shift light....but i'm sure the megasquirt can do the same thing or something similar

I have the Link but on a 92 that channel is used for the WBO2

yeah, the hell with that. i'd much rather just listen to my engine than have to a) look at the thing and b) explain what that light does. that and it may invite unwanted ricer conversations.

how often do you want to be asked if you drift your car? there is a reason i like sleepers.

Same here i just use my ears. Its not hard to tell when your motor is revving high and HARD.

if you are looking down to see the check engine light you should see the damn tach too!

if you really want one, do something discreet. Take the lead for the light and run it to a inset led on the top underside of the gauge pod (so it'll look like an auto alarm led) and then add an on/off switch. You'll see it without the jdm ricey poser after taste.

I bought some ricer interior LED's from the auto parts store, trimmed and painted them and put them in my pillar pod and hooked them up to my F/IC. You can hardly tell they're there. They're not really necessary but I was bored one day. I'll try and get a pic.

I, and everyone else here, wish you would check out this:

http://www.alamomotorsports.com/greddy/greddy_shift.htm

what if we just want 1 output to be active (for vics control)? I don't understand the dual output sequence. I have a pnp btw.

Something discreet, is what I am looking for, but I will have to get a stand alone unit as the Link does not have an output for a shift light if you use a WBO2 .

What da'hell does a shift knob have to do with this topic?

its a trick to log you out but someone doesnt understand PHP.

fuck, I'm gay.

ohhhh... that sucks :noob:

Logged out

Good bye.

One less Forum Suporter.(Subscriber)

It actually logged you out? :bowrofl:

Seriously though, I'm not trying to be flip with you, but you clicked on a link and are upset with the forum because of what the link contained? It's the web dude, it happens all the time. What did it take, all of 4 seconds, to log back in?

what a pussy.