is there a such thing as -AN caps/plugs?
so due to a series of unfortunate events, im going to need to revert to N/A for a bit while i repair some stuff on my turbo, and this is my daily driver.
i didnt happen to hang on to the engine plug bolt that plugs the oil feed (I have a 1.6) and i know it is M10x1.5 but does anyone know how long it was?
also, what should I do about my drain line? is there a such thing as an AN cap or something i can either thread over the oil pan fitting, or into the turbo end of the drain line and just zip tie the hose out of the way?
thanks for any help/suggestions
i didnt happen to hang on to the engine plug bolt that plugs the oil feed (I have a 1.6) and i know it is M10x1.5 but does anyone know how long it was?
also, what should I do about my drain line? is there a such thing as an AN cap or something i can either thread over the oil pan fitting, or into the turbo end of the drain line and just zip tie the hose out of the way?
thanks for any help/suggestions
Joined: Jun 2005
Posts: 19,338
Total Cats: 574
From: Fake Virginia
yes. summit. jegs. jcwhitney. favorite race shop.
BAM: http://pitstopusa.com/i-5062044-earl...cap-10-an.html
BAM: http://pitstopusa.com/i-5062044-earl...cap-10-an.html
Oscar im thing I'll need to add a 'lots of duct tape' step in there right?
But thanks for the quick response everybody. I ordered some from summit. Are those ok for the pressure from the oil feed? I'm guessing so.
But thanks for the quick response everybody. I ordered some from summit. Are those ok for the pressure from the oil feed? I'm guessing so.
Joined: Jun 2006
Posts: 29,085
Total Cats: 375
From: Republic of Dallas
Joined: Oct 2007
Posts: 6,029
Total Cats: 304
From: The coal ridden hills of Pennsylvania
I had to remove my turbo a while back. I welded a -4 fitting to a coupling and threaded a barbed fitting into it and hooked that up to my oil drain line. Perfect for temporary use.
Do it.
Do it.
I already ordered the caps do I'm just Gunna go with that for now. That way I can keep the block fitting and crush washer in tact. Also, no access to grinder or cutter or welder so this is a better option for me. Did your oil pressure not drop having no restriction on that oil feed line?
And curly, I think I was just over thinking it, I was worried if it was too long it would block a passage inside the block so I thought I would ask. But thanks for letting me borrow your spoon
And curly, I think I was just over thinking it, I was worried if it was too long it would block a passage inside the block so I thought I would ask. But thanks for letting me borrow your spoon
Thread
Thread Starter
Forum
Replies
Last Post
bigmackloud
Miata parts for sale/trade
19
Jan 8, 2021 11:24 AM
StratoBlue1109
Miata parts for sale/trade
21
Sep 30, 2018 01:09 PM








