Where did you buy your turbo oil feed line??

Reply Subscribe

Thread Tools

Search this Thread

Sep 17, 2011 | 05:37 AM

#21

Savington

Former Vendor

iTrader: (31)

Joined: Nov 2006

Posts: 15,442

Total Cats: 2,106

From: Sunnyvale, CA

Quote:

Originally Posted by v01canic

not to revive a super old thread, but can some one tell me what length line i should be using for a 1.6L

Thanks

Depends on a ton of stuff. Decide where you're routing the line, then decide how long it needs to be.

Sep 17, 2011 | 07:04 PM

#22

shlammed

Elite Member

iTrader: (8)

Joined: Dec 2008

Posts: 2,910

Total Cats: 51

From: Kingston, Ontario

use the oil fitting on the rear of the block near the trans. order 3 foot length and cut to fit.

Sep 18, 2011 | 12:28 AM

#23

v01canic

Junior Member

iTrader: (1)

Joined: Oct 2009

Posts: 221

Total Cats: -2

was planning on getting a pre-assembled stainless line and i will for sure be using the oil feed line on the side of the block.

Thanks again.

Sep 18, 2011 | 12:33 AM

#24

wittyworks

Senior Member

iTrader: (6)

Joined: May 2009

Posts: 983

Total Cats: 23

From: San Francisco

You can use a Piece of wire or thin rod to figure out where you're routing the line, then measure off of that how long you need.

Sep 18, 2011 | 01:10 AM

#25

TorqueZombie

Elite Member

iTrader: (6)

Joined: May 2011

Posts: 1,656

Total Cats: 64

From: Albuquerque, NM

When I prime the Turbo I squirt as much oil in it as I can, then hook up the line, and turn the motor over with no fuel till the oil gauge shows pressure. Bam. Primed. If there is a better way let me know.

Sep 18, 2011 | 01:26 AM

#26

karter74

Senior Member

iTrader: (4)

Joined: Feb 2006

Posts: 690

Total Cats: 23

From: Centennial, CO

A much easier way, albeit scary is to hold the compressor still with your hand and have someone start the car. Voila, primed turbo in seconds!

Sep 18, 2011 | 02:08 PM

#27

triple88a

Elite Member

iTrader: (2)

Joined: Apr 2006

Posts: 10,522

Total Cats: 1,830

From: Chicago, IL

Squirt some oil and blow in the hole...

Attached Thumbnails

Where did you buy your turbo oil feed line??-fatty_boom_boom_04.jpg

Reply Subscribe

Related Topics

Thread

Thread Starter

Forum

Replies

Last Post

Partial Turbo kit for a 1.6 and dual headlight kit.

Andifer

Miata parts for sale/trade

Sep 23, 2015 05:43 PM

1991 Turbo Miata partout

tottestad

Miata parts for sale/trade

Sep 14, 2015 07:52 PM

New here, saying hi, here's what I'm workin with.

SuperSneakySecretSquirrel

Meet and Greet

Sep 6, 2015 08:30 PM

Advanced Engine Dynamix Review (dead oil pump content)

itsMikey

Insert BS here

Sep 5, 2015 02:56 PM

Thread Tools

Search this Thread

Show Printable Version

Email this Page

Reply Share

First
Prev
2 / 2
Next
Last