GB Billet Oilpump Gears
#43
Elite Member
Thread Starter
iTrader: (39)
Join Date: Sep 2007
Location: High Point NC
Posts: 4,850
Total Cats: 8
Travis, after the initial run of 18+ gears has been made, what are we looking like as far as them stocking this item for us. Will we pretty much need to run a small group buy of at least 18 units each time, or is that just this once to offset the machinist set-up time etc.? I am so ready for a set, just say when and where and I'll go rob a 7-11.
#44
Hey guys, I didn't get around to completing this yet. I've had to work alot last couple of days. As far as stocking them, I pretty much have to buy them in units of 18 or greater. I could of stocked them if I had put out a price of around 280-290 on them for a little bit of profit on these gears, but this price doesn't leave me any skin to offset the next load. I don't want to have to front the 3k+ bill to have them in stock either. We'll have to see, right now money is tight, if work really gets to moving again I might front it, but it'll have to be more then at cost. Thats alot of money & time to invest to get nothing out of it. Otherwise we can work in chunks of 18+ if there is enough interest.
#46
Elite Member
Thread Starter
iTrader: (39)
Join Date: Sep 2007
Location: High Point NC
Posts: 4,850
Total Cats: 8
In that case, I would do the same thing...Money up front and treat it as a groupbuy each time...if you need help setting it all up shoot me a PM and I'll see what I can do as I have a bit of free time now.
#50
Alright, its a confirmed deal. www.boundaryengineering.com you can find it under internal components or on the side. I'm going to leave it up for a few days, and let everyone order.
For people who are not in the lower 48 pay the upfront fee for the part and then when it gets time to ship I'll let you know if you need to pay more.
Travis
For people who are not in the lower 48 pay the upfront fee for the part and then when it gets time to ship I'll let you know if you need to pay more.
Travis
#54
Any parts that don't fit will be reworked by the machine shop, but if it turns out not to be the gear thats outa spec, you'll have to look at your block and housing. All the parts will be inspected for fit before they leave so it is very unlikely you'll run into fit issues... ETA is about 1 month.