ugh
just removed my roll bar
the previous owner had it welded in not even correctly
had to sawzall FTL!! probably won't be able to put another one again ever
i still have mounting plates in rear and stubs coming up about 3 inches

anyway reservoir is full, harnesses are all connected
never had an ABS light until the moment i cranked the car after roll bar removal

any pics of what i should check, anyone have this before??
**** MY LIFE RIGHT NOW

 

You probably have sawzalled/disconnected one of the signal cables, going to the rear hubs. The signal cables for the rear run through the right door sill. The right one goes straight through the tunnel next to the gas tank, while the other one runs in front of the gas tank, under the metal cover.

Try pulling both wires at the rear wheels. If one happens to be loose or pull through, that's your problem.

EDIT: also check your fuse

 

holy **** calvin! you know what i just realized it is!

.............no wires got cut......i remember cause i checked after i cut ur bar out, but before i startsed cutting i noticed one wire in the way so i unplugged it! that why you light is on!

i didnt remember till i read Coco's post!

 

co co is a no no?