|
Note: When using the Bosch Sensors the LC-1 may perform multiple calibration passes. This is normal and need not cause concern. When it completes, the LC-1 also will perform a free air calibration. Make sure the sensor is operating in free air for the heater and free air calibration. |
so I think it's working again. my calibration may be questionable but that's ok for now.
I believe my issue is that the terminator and serial connection are weak pieces of crap. I re-seated them a few times and checked all the connections and now it seems to be ok. incidentally, Innovate is dumb because they ignore the onboard calibration resistor value. |
| All times are GMT -4. The time now is 03:02 PM. |
© 2024 MH Sub I, LLC dba Internet Brands