I drive a 89 mazda 323 with a b6t swap. Im new to the miata forum. Not sure that anyone wanna see, but if u need pix just ask

 

why I have to ask? Why can't you just post pics?

 

since i dont drive a miata...prob most people dont really care

 

What's going on?

 

 

 

oh nice! that is super rare man !
Any mods? I see really nice bends on that ic piping

 

its a b6t from a capri xr2 (same as the 1.6 miata) just rebuilt the motor less than 5k ago. Head got decked and new valve seals, block got decked,hot tanked,bored .20 ova with auto miata pistons,honed,arp rod and head studs, 2.5" exhaust with magnaflow muffler, rx7 460s, tuned vaf to lean it out a lil, all new gaskets,seal,oil pump, t-belt and water pump, 15psi on stock vj14. New setup will include t3 and MS.

 

oh really nice, that sounds like a lot of fun to come in the near future. Looks like you did your hw and put the right work onto the build. Do you already know what t3 manifold you are going to run? I think you are the envy of the community because you actually have back seats !

 

Im going with a JGS manifold..and hope im not the envy of cuz i have a back seat lol....i have a miata engine