1200rpm cutt off
#41
I figured if that was the case it would show correct off the cpu pin but not at the db37 connector area
edit:
Also does anyone know if MS1 spark outputs have to be setup in order
spark A and spark B
I can't seem to get Spark B and Spark C instead to work with the correct mods to that area
I went in and set trigger position c to 2 and trigger posistion a to 0 with trigger position b still at 1
hmm I guess trigger position refers to something else, will test again in a minute.
nevermind, wastedspark 4 cylinder MS1extras has to be spark a and spark b output. Ain't that effing great.
edit:
Also does anyone know if MS1 spark outputs have to be setup in order
spark A and spark B
I can't seem to get Spark B and Spark C instead to work with the correct mods to that area
I went in and set trigger position c to 2 and trigger posistion a to 0 with trigger position b still at 1
hmm I guess trigger position refers to something else, will test again in a minute.
nevermind, wastedspark 4 cylinder MS1extras has to be spark a and spark b output. Ain't that effing great.
Last edited by Techsalvager; 09-11-2010 at 04:03 PM.
#43
at idle both show correct outputs
_-___-___-___-etc
and
_---___-___---___-__etc
What I noticed is one of the spark outputs is not working at all
so what I've been running on is 2 cylinders.
one is correct _-__-__-__etc
the other is ------- full on 5v out from the cpu pin to the db 37 pins
What If ound out is both circuits work correctly, but it seems whichever is hooked onto pin 36 goes high 5v. Makes me wonder if my db37 connector is at fault. I'm gonna bypass the connector and connect it at the harness I built to test.
Thread
Thread Starter
Forum
Replies
Last Post
itskrees
Engine Performance
1
05-06-2015 02:49 AM