So the other day i was looking at my laptop with it plugged into my DIYPNP and i noticed my map sensor was reading 80 to 88 kpa witch seamed too low for only being about at most 500 to 1000 feet above sea level. Th map sensor is less then 6 months old so is it and could it already be bad?

 

is it calibrated properly to the ms?

 

I have it set to MPXH6400 like diy says to do.

 

this is what i get with KOEO

 

here in salt lake city, elevation 4400ft, my map when MS is turned on reads 88

it is also a 4 bar map sensor