94 N/A running rich with all maps
05-17-2017, 10:43 AM
#22
Supporting Vendor
Join Date: Sep 2006
Posts: 2,332
Total Cats: 67
A problem in one injector is more likely to be hardware (and less likely to show up in TunerStudio). Try checking the voltage on the wire to the injector with the key on, engine off, and fuel pump fuse pulled to avoid flooding the engine. It should have battery voltage on all four - if one is grounding out, check to see if the driver is receiving 5 volts from the processor (code / settings issue) or has zero volts (failed driver).
Reply
0
0
05-27-2017, 03:05 PM
#23
Junior Member
Thread Starter
Join Date: May 2016
Location: Monterey
Posts: 61
Total Cats: 3
Alright, voltages off the board (and at the injectors) are the same for 2-4 at 11.8ish volts. Injector 1 is the only one getting 5.8ish volts. This seems to be backwards from what was expected. Any ideas? I'm probably going to take off the sequential injection mod for now and see if the issue changes.
Reply
0
0
05-27-2017, 05:16 PM
#24
Junior Member
Thread Starter
Join Date: May 2016
Location: Monterey
Posts: 61
Total Cats: 3
Alright, went back to untimed/batch injection and car runs perfect. Do I have a bad sequential board? Did I install it wrong? It's pretty simple seeming, solder on header, run INJ 3 and 4 on the seqmod board to 3 and 4 on the main board right?
Reply
0
0
