AFAIK those can both be used at the same time.

 

CAN is a multidrop bus

 

So I've followed what was said here in terms of settings and hooking it up and Im still not getting connectivity from the wideband to the ms3propnp, is there something else that I could be missing?

 

Sub'd. Getting ready to connect AEM 30-0300 to a can module & MS3 pro w/FW 1.4.1

 

Post your tune so I can see your settings.

 

You will need different settings. Andrew has links.

MSLabs CAN Wideband Module

 

Ok, good stuff. I bought it though TSE, so I'm aware of what's posted there. I'm still just casting a wide net and trying to learn from what other folks are doing to get this set up right.

 

I love the research, just know that x series straight to megasquirt is completely different than what's happening with your setup.

 

I'll have to do it when I get home, are there any specific settings you need to see?
I'm still new to the MS setup and have not done anything with the car other than first start.

 

Well we actually got it sorted, the gauge wasn't sending any kind of signal out

 

Did you guys use termination resistor on the AEM end?

 

Nope just wired can H and can L to each other and set it up in tuner studio.

 

Does the newer MTX-L Plus work with the MSLab CAN Module?

 

Thanks to all that posted their settings! I am also doing an 30-0300 on an MS3PRO PnP and there's still one setting I'm a bit confused about. Under "calibrate AFR table", what are you putting into "EGO sensor"? Since the AFR gauge will be using CanBus now, and not an 0-5v signal, is this even relevant? Should I select the blank option in the pull down and write that to the controller?

 

No need calibrate AFR if you're using the CAN bus since that's only for the analog signal.

 

It's been a few months into 2021, are there any new info updates on OP's particular wideband? I moved away from the MTX I bought a few years back and was thinking about this one for my MSM project too. From what I'm gathering it's a lot more straight forward of a process than using the older analog widebands?

My apologies if my questions have super obvious answers, or are too general for a useful answer. I've been out of the game for a LONG time on my build and I'm trying get back into the hang of things 😂

 

(Not OP) I can confirm using AEM X-Series via CAN w/ MS3ProPnP works great. 9/10 would recommend, only caveat being using AEM Net precludes you from using other CAN devices with MS3 IIRC

 

One day these semiconductor shortages will end and this will go back in stock (woo native wideband). I've been trying to buy one for about a year now...

https://www.14point7.com/products/spartan-3-adv

 

Would having a MSLabs CAN wideband module allow you to avoid the AEM Net problem of shutting down the ability to connect anything else via CAN?

 

Hello, I hope you can help me:
I have this configuration with the FW 1.5.2RC16 and the wideband does not read me
I have tried changing the CAN ID of the wideband and it doesn't work either.
what am I doing wrong?