i chose the ini that i downloaded from the write up and no go.

i dont see the one its telling me to choose in my list of ecudef either


http://i90.photobucket.com/albums/k254/los561/ecu.jpg

http://i90.photobucket.com/albums/k254/los561/ecu2.jpg


am i supposed to connect anyway after selecting the downloaded .ini file that is in the ms2 extras?

 

 

you have an older firmware loaded.

you need this locally for your project: http://www.msextra.com/doc/ms2extra/...u_20100522.zip

 

why am i getting the same values for closed and full throttle adc? there is also a ticking that goes on and off every 3-5 seconds sounds like its oming from the steering column

-getting a conflict with tacho output too.

 

email me your msq. ticking would be fuel pump relay.

 

i dont know what msq is or how to email it. this is all very new to me

 

just figured it out, sent msq file.

 

changed my tach out option and still have config error. cannot get the closed and full adc count they are bothing showing up the same value as closed count after i hold gas down and try to get full adc

 

just run the base map from diypnp for 99. i used that and car fired right up