Check whats your current Calibrate AFR table ?
Thread Starter
Junior Member
Joined: Jun 2009
Posts: 55
Total Cats: -3
Check whats your current Calibrate AFR table ?
Is there anyway to check whats your current Calibrate AFR table setting is? Seems like its gone after you burn it? Its been too long since I last touched the MS3, I just want to double check everything before I start tuning it again.
And under " Tools -> Calibrate AFR table -> Innovate LC-1 Default " does the "Default " mean the TunerStudio uses this a default AFR table?
P.S. Using MTX-L Wideband here
And under " Tools -> Calibrate AFR table -> Innovate LC-1 Default " does the "Default " mean the TunerStudio uses this a default AFR table?
P.S. Using MTX-L Wideband here
Reply
0
0
Supporting Vendor
Joined: Sep 2006
Posts: 2,332
Total Cats: 67
This setting is pretty much one-way.
The "default" refers to the settings in the LC-1, not the MS3. The MS3's default calibration is for a narrow band.
The "default" refers to the settings in the LC-1, not the MS3. The MS3's default calibration is for a narrow band.
Reply
0
0
Thread Starter
Junior Member
Joined: Jun 2009
Posts: 55
Total Cats: -3
Reply
0
0
