I'm getting conflict when trying to enable launch control. I'm using a mspnp gen 2, the only things changed from the diyautotune 9093 331a base map is the trigger angle offset. The MS2/Extra release 3.3.3. I think I read the 3.2.1 and older versions would show the Lanch pin as Flex. but I don't see that option under the Launch Control Menu - Input pin. My only listed options are Launch, Tableswitch, Baro, Knock, Remote Port 3 (Bit0), Remote Port 3 (Bit1), Remote Port 3 (Bit2), Remote Port 3 (Bit3), Remote Port 3 (Bit4), Remote Port 3 (Bit5), Remote Port 3 (Bit6) and Remote Port 3 (Bit7).

I replaced the clutch switch this afternoon, and wired pin 9 from the MSPNPGen2. 1.2 board to the brown and white wire from the stock harness.

I'm not sure what I'm missing to fix or even to cause the conflict. Can any help with the issue?

 

Thanks Matt, the pin was assigned to A/C idle up.