Going to try to load the Hi-Res firmware today for my MSPnP. Following the instructions from here http://ozmx5.com/viewtopic.php?f=4&t=13 it says to copy your existing project folder. My existing project folder was using the MAF but the copy of Hi-Res I'm going to be running is for the GM IAT sensor. Should I still copy my original project folder, or should I copy the project folder for no MAF (that I haven't used)? Does it make a difference?

 

From my limited experience with MS... I would make one major change at a time. So either get it running with the IAT THEN switch to the HiRes or switch to HiRes then get her running with the IAT once that's all done.

 

yeah i'd switch to running the gm iat, make sure it works, then switch to hi-res

 

+1

 

er...to late for that. Probably would have been a good idea though. Still doesn't answer my question.

 

I'm the author of those instructions and I agree with what everyone has said about one change at a time. To answer your question; if you want to change to HR and lose your MAF at the same time you should copy the "no MAF" project folder.

 

I would have liked to change one thing at a time but time constraints didn't really allow that. If **** doesn't work right I know it's my own fault. Thanks for the answer though.