I am a newb to tuning and need some help. I have started tuning my car and at no throttle at 3100 rpms my car is really rich. However, my ve table has a value of approximately 1 in this cell. Do I need to lower my required fuel to allow me to shift my table up and allow me to lower the fuel in this cell more.

My car is running 440 injectors, stock in tank pump, inline Pierburg fuel pump, with stock fuel pressure rail and regulator. I am not running sequential fuel yet but will be switching over in 2 weeks when I'm on a break from school.

Here is a screen shot of the tune and datalog.
.

I added about 8 points of fuel to top right hand corner of the fuel table to try and eliminate the fuel from falling off, but do I still need to add more or does this look good.

Here is a copy of my current setup. I am open to any advice and appreciate input.
2014-03-06_12.26.22.msq

For some reason I could not get a datalog to upload even after I made it smaller.

 

Maybe I'm missing something but why is there no fuel load?

 

Onyxyth are you asking why there is no afr load on my datalog screen shot.

 

Here is part of my datalog
2014-02-21_12_modified.msl