9697 MSPNP- lean after restart
#1
Senior Member
Thread Starter
iTrader: (4)
Join Date: Oct 2006
Location: Tampa
Posts: 780
Total Cats: 0
9697 MSPNP- lean after restart
Here is the scenario. The car starts up fine from cold and warms up normally. After the car has warmed up to operating temperature I can shut the car off and restart it. Once again it will restart fine, but it will run really lean, say 17.0 or so on the AFR's, for short while. The car is driveable, and when driving, the car has good AFR's, around 14.5 at cruise. Once I come to a stop the AFR's are back to normal for idle. I am not sure what to check in Megatune to correct the problem. Do I need to adjust my ASE at the 160 degree mark? I havent messed with the ASE since I got it from DIY. I dont think it would be the cranking PW since the car starts a-ok.
As always, thanks guys.
As always, thanks guys.
#2
Supporting Vendor
iTrader: (33)
Join Date: Jul 2006
Location: atlanta-ish
Posts: 12,659
Total Cats: 134
Does it drive ok? If so, leave it alone. If you need some more fuel, it's in the coolant related temperature correction--which actually is AIT based correction to combat heat soaked AIT sensor. Which is what your problem is.
#5
Senior Member
Thread Starter
iTrader: (4)
Join Date: Oct 2006
Location: Tampa
Posts: 780
Total Cats: 0
The explaination helped me understand the cause. Thanks to all of you for your advise.
Thread
Thread Starter
Forum
Replies
Last Post