Installing ms3x...crazy noise when key on...
Wtf is this noise?!?!
Ms3x install noise: |
IACV?
|
IAC? Pull ze plug.
|
IAC. Check the frequency setting.
|
Ahh ok thanks guys! It's not going to hurt anything buzzing like that is it? I was concerned something was wrong so I shut the car down right after recording the clip
|
shouldn't hurt but don't want to roast it. maybe this helps?
https://www.miataturbo.net/megasquir...equency-48120/ |
Not right away, no. If you don't use the correct frequency setting it will kill the valve.
|
Ok thanks again! I'm going to unplug it until I get the setting correct... Getting back out in the garage after dinner and wife-time lol
|
"wife time":ky:
|
FWIW, mine was noisy in my basemap from Rev @ 313hz, bumped to 480hz (per 500hz suggestion in linked thread above... it's as high as I can go) and is a low hum now.
|
1 Attachment(s)
Originally Posted by psyber_0ptix
(Post 1119559)
"wife time":ky:
Ok next dumb question... Did I do something wrong? Are wires backwards on my TPS? I have a pnp TPS sensor from the guy on here who sells them all the time, so I doubt he wired it wrong https://www.miataturbo.net/attachmen...ine=1397003937 |
Ok so also I ended up bumping the Inc frequency to 503hz.much quieter now... Hopefully that's not too high of a setting.
Off work tomorrow and can't wait to VE analyze and drive around and see what it does! |
Don't VE analyze anything until everything is calibrated properly.
|
Originally Posted by thirdgen
(Post 1119662)
Don't VE analyze anything until everything is calibrated properly.
|
Right. You either wired it wrong or calibrated it wrong.
|
I'll see if I can either flip the connector or maybe I misunderstood brains instructions
|
Originally Posted by BTMiata
(Post 1119663)
I have everything else calibrated... I just need to find out about that TPS message I had pop up
If it's not reading 0 when closed, and doesn't go positive numbers when you hit the pedal, something is wrong. |
Ok so the plug is not backwards... Its either incorrect wiring or I improperly did the procedure. I'm pretty sure I followed brains instructions exactly though
|
did you actually install a vTPS?
the buzzing is actually a bit bothersome, since the freq you should be using is whatever was loaded (something like 100Hz). |
1 Attachment(s)
Originally Posted by Braineack
(Post 1119787)
did you actually install a vTPS?
the buzzing is actually a bit bothersome, since the freq you should be using is whatever was loaded (something like 100Hz). https://www.miataturbo.net/attachmen...ine=1397044720 |
All times are GMT -4. The time now is 04:00 PM. |
© 2024 MH Sub I, LLC dba Internet Brands