Knock Detection for MS3
Thread Starter
Junior Member
Joined: Jul 2013
Posts: 319
Total Cats: -11
From: TX
Knock Detection for MS3
Hey guys,
So I've been looking at my knock gauge in the TS software (Gauge is called knock input)
And I've noticed that my knock never goes past 11-12 percent. Is that normal? I know that the factory knock sensor isn't that great, but I'd imagine I'd see much knock than that, just from engine noise alone.
My next question, is there a way for the CEL to illuminate when it triggers knock?
So I've been looking at my knock gauge in the TS software (Gauge is called knock input)
And I've noticed that my knock never goes past 11-12 percent. Is that normal? I know that the factory knock sensor isn't that great, but I'd imagine I'd see much knock than that, just from engine noise alone.
My next question, is there a way for the CEL to illuminate when it triggers knock?
Reply
0
0
Joined: Apr 2014
Posts: 18,643
Total Cats: 1,870
From: Beaverton, USA
Reply
0
0
Thread Starter
Junior Member
Joined: Jul 2013
Posts: 319
Total Cats: -11
From: TX
Reply
0
0
Thread
Thread Starter
Forum
Replies
Last Post
FAB
Fab9 Tuning - Miata Performance Parts
21
Jun 8, 2020 07:01 PM
Little Badger
Suspension, Brakes, Drivetrain
4
Oct 15, 2015 12:18 PM
nick470
MEGAsquirt
0
Oct 5, 2015 02:45 PM
