juniorworks

Hello y'all. First post.


Just finished up installing my Kraken 2560r kit and got the car running well on wastegate.

Bought the DIYAUTOTUNE EBC solenoid kit and wired it according to instructions (19.5-40 Hz frequency, port 2 to WG, port 3 to compressor housing, one wire to 12v, one wire to option #7 on MS). Enabled boost controller in MS. Burned the boost table below (going from 0 (open WG) to 100 (closed WG) at 0 RPM, from 0-100 TPS).



Here are some screenshots:






Boost table (first column is for bench testing):







Long story short: it's not working. I don't hear the solenoid switching when pressing the accelerator at 0 RPM. I can hear it switch if I swap the output polarity but it either stays fully open or fully closed. Manually switching the solenoid with 12v and ground works.


Any ideas?

juniorworks

Attached is my tune.

juniorworks

Nvm, got it figured out. Used a different 12V supply.

Z_WAAAAAZ

Props for following up after figuring out the issue. Good luck with the rest of the setup!