MS1 random cut out while cruising
#21
I, too, have the same issue.
MS1 v3 DIY built myself following the original thread.
I am getting dropouts around 3.5k RPM, so basically highway cruising.
I was able to follow the instructions pretty well to build the MS board as the picture tutorial was great. I tried to read the schematic but I am not 100% sure as I do not know symbols for everything. I used my mad MSPaint skills to add on to DIY's mod photo to show how I would solder in this 2nd opto circuit.
Can anyone confirm that this is correct?
MS1 v3 DIY built myself following the original thread.
I am getting dropouts around 3.5k RPM, so basically highway cruising.
I was able to follow the instructions pretty well to build the MS board as the picture tutorial was great. I tried to read the schematic but I am not 100% sure as I do not know symbols for everything. I used my mad MSPaint skills to add on to DIY's mod photo to show how I would solder in this 2nd opto circuit.
Can anyone confirm that this is correct?
#25
Looks good, Just remove the original 2 resistors (Red Lines) that go from IAC1A to 5v and js8. I build my circuit on one of these: Dual General-Purpose IC PC Board : PC Boards | RadioShack.com and mounted it in the case.
That seems like a neat way to do it
edit:
Parts list of what I just ordered
Last edited by kero; 12-11-2013 at 08:30 PM.
#26
Elite Member
iTrader: (2)
Join Date: May 2007
Location: Cromwell, Connecticut
Posts: 2,605
Total Cats: 16
My MS has been changed so much over the years I gave up on my sloppy proto area. I just recently used that radio shack board in an external enclosure and just popped the necessary wires out of my MS enclosure to use for VCCS Sucks, but it was the easiest way.