Hi!! As I haven´t got the inst. manual I need to ask where must i solder the 5 colored wires
Orange
Yellow
Grey 1
Grey 2
Blue
Green
Purple
Thanks in advance!!

 

Hopefully, Dimitris, from MS Labs get in contact with me and he has solved most of my problems.
This is the units controlled via the colored wires:
• Yellow - Wideband input. Connect this to your wideband analog output

• Grey - Switchable tables. Connect this to a ground (through an on/off switch) to switch between VE/Ignition tables.

• Brown - Launch control. Connect this to a ground (through an on/off switch) to switch launch control on/off.

• Violet (purple) - Boost control low/high. Connect this to a ground through an on/off switch) to switch between low/high boost tables

• Green - Boost control output. Connect this to a boost control valve. The other wire of the boost control valve needs to be connected to a switched and fused 12V source. A 5A fuse is recommended.

• Orange - Free programmable output 1, low side. Can drive any load up to 0.5A.

• Blue - Free programmable output 2, low side. Can drive any load up to 0.5A.


I hope this may help somebody someday.