When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
alright you all, so i followed all the installation steps to include connecting the map wites to the maf sensor, connecting the vacuum line to the manifold, and connecting all of the ecu plugs to the ms3 itself. i turned the key to the ON position and went intovtuner studio to load the base mapcand it said the controllerncould not be found. the screen says i need to install some COM port drivers, but how? this always seems to happen to me with stuff like this key is on, dash ismon radio is on and it cant find the ms3 pro pnp
okay so i installed my megasquirt and installed a new fuel pump. i'm running the 1.6 base tune and i have a narrowband o2. i got about 7 miles to the gallon today driving to and from work and i don't understand why. i could either be running super rich or i have a fuel leak. i'm letting the car cool right now so i can troubleshoot later. i'll post the logs i took this morning to see if any of you guys see anything fishy. for some reason i'm unable to open them in megalog viewer.
I dont understand, all O2 sensors Ive ever dealt with narrow or wide, had the same thread size. What the hell did you buy?
Washing down your engine with gas, is really really bad for its health. It will be surprising if this car lives until Friday, or much after thAT..
the exhaust i got was very cheap and the bung was too far from the sensor and directly facing the transmission, so i couldn't even extend it and use the bung, so i had to drill a hole closer to the sensor. the tap that i have is too soft for the metal used to make the header so i was left with a big hole in the exhaust. i opted to just use exhaust system sealer (the chalky white one) and metal clamps to secure the o2 sensor in the exhaust. if you read my last few posts in this thread the vehicle wasn't running rich. the o-ring on cylinder 4 got damaged and was leaking so i fixed it and now it's running just fine. it should be just fine until i pull it apart on friday.
Base tunes aren't for driving. They are for getting it cranked so you can tune it.
How many threads are you going to start asking the same questions? Which shall I consider the real one?
that was my mistake. i was kind of in panic mode when i first started so i posted more than once because i didn't understand the issue i had. the car wasn't running rich, it was just leaking fuel.
07-08-2018, 12:57 AM
need some serious help with ms3 pro pnp
0
