quick ms2 wbo2 lc1 wiring question
#1
Junior Member
Thread Starter
iTrader: (4)
Join Date: Feb 2009
Location: Raleigh, NC
Posts: 318
Total Cats: 0
quick ms2 wbo2 lc1 wiring question
says:
"Your Wbo2 input is the pink wire left dangling on the harness, labeled o2, or on the center connector plug, also labeled. Connect your 0-5v output from your WBo2 to this wire."
and: "Your Wbo2 input will connect to the labeled DB15 wire. Connect your 0-5v output from your WBo2 to this wire."
SO- my pink wire is labled o2, but it's not dangling, it's connected at both ends. I'm assuming I should cut it and wire to the end going to the Megasquirt? I dont get the db15 wire part
Other question, grounds on the '94 are up front under the TB, right?
"Your Wbo2 input is the pink wire left dangling on the harness, labeled o2, or on the center connector plug, also labeled. Connect your 0-5v output from your WBo2 to this wire."
and: "Your Wbo2 input will connect to the labeled DB15 wire. Connect your 0-5v output from your WBo2 to this wire."
SO- my pink wire is labled o2, but it's not dangling, it's connected at both ends. I'm assuming I should cut it and wire to the end going to the Megasquirt? I dont get the db15 wire part
Other question, grounds on the '94 are up front under the TB, right?
#2
Senior Member
iTrader: (4)
Join Date: Jan 2008
Location: Falls Church, VA
Posts: 1,361
Total Cats: 17
says:
"Your Wbo2 input is the pink wire left dangling on the harness, labeled o2, or on the center connector plug, also labeled. Connect your 0-5v output from your WBo2 to this wire."
and: "Your Wbo2 input will connect to the labeled DB15 wire. Connect your 0-5v output from your WBo2 to this wire."
SO- my pink wire is labled o2, but it's not dangling, it's connected at both ends. I'm assuming I should cut it and wire to the end going to the Megasquirt? I dont get the db15 wire part
"Your Wbo2 input is the pink wire left dangling on the harness, labeled o2, or on the center connector plug, also labeled. Connect your 0-5v output from your WBo2 to this wire."
and: "Your Wbo2 input will connect to the labeled DB15 wire. Connect your 0-5v output from your WBo2 to this wire."
SO- my pink wire is labled o2, but it's not dangling, it's connected at both ends. I'm assuming I should cut it and wire to the end going to the Megasquirt? I dont get the db15 wire part
Maybe he leaves the O2 wire connected at both ends for people who want to get it running on the stock narrowband sensor first, I dunno. But yes, you will need to run the signal from the LC-1 to the MS, and you will need to cut the wire to do that. To the side that goes to the MS you will attach the brown or yellow wire from the LC-1. I believe the sick golden showering poo eaters at Innovate made the yellow wire #1 and the brown wire #2. Double check that though because it's been quite a while since I wired mine up.
Other question, grounds on the '94 are up front under the TB, right?
Thread
Thread Starter
Forum
Replies
Last Post
StratoBlue1109
Miata parts for sale/trade
21
09-30-2018 01:09 PM