No cam signal (MS3)
Thread Starter
Junior Member
Joined: Nov 2013
Posts: 286
Total Cats: 28
No cam signal (MS3)
Had VVT head. Swapped to non-VVT head. Cam sensor wiring was extended, but wired the same as before. It has ground, reference, 12v going to it.
Not getting a signal for it in the MS.
Have 36-2 trigger wheel (spark mode set to Miata 36-2). Ignition input I've tried both rising and falling edge.
Have tried 3 different cam sensors. One from a 99, other two came out of the previous VVT head at various points. I know for a fact at least one of them was working last year. Unlikely any of the 3 are actually bad.
Attached is composite log if it's of any use? Unsure what else to check. Also attached current tune.
Not getting a signal for it in the MS.
Have 36-2 trigger wheel (spark mode set to Miata 36-2). Ignition input I've tried both rising and falling edge.
Have tried 3 different cam sensors. One from a 99, other two came out of the previous VVT head at various points. I know for a fact at least one of them was working last year. Unlikely any of the 3 are actually bad.
Attached is composite log if it's of any use? Unsure what else to check. Also attached current tune.
Reply
0
0
Thread Starter
Junior Member
Joined: Nov 2013
Posts: 286
Total Cats: 28
This is how I have the cam sensor wired: https://i.imgur.com/mkG2va7.jpg
Left to right - ground, signal (green/yellow wire from car - '96), 12v.
Left to right - ground, signal (green/yellow wire from car - '96), 12v.
Reply
0
0
Thread
Thread Starter
Forum
Replies
Last Post
NiklasFalk
Engine Performance
11
Feb 20, 2014 03:56 PM
