No tach after flow force cop install
Thread Starter
Newb
Joined: Apr 2019
Posts: 8
Total Cats: 2
From: South Jersey
No tach after flow force cop install
Okay iv been forced to ask this question I’m running out of ideas.
Switched to Flowforce COP now I have no tach. I have jumped b/w & b/y wires from igniter and put a 1k resistor between ig and b+ in the diag port. Made sure tach out was switched on in MS3pro. Still no tach.
Anyone have any ideas?
Switched to Flowforce COP now I have no tach. I have jumped b/w & b/y wires from igniter and put a 1k resistor between ig and b+ in the diag port. Made sure tach out was switched on in MS3pro. Still no tach.
Anyone have any ideas?
Reply
0
0
Junior Member
Joined: Jun 2015
Posts: 182
Total Cats: 58
From: VIC, Australia
I believe you need to connect the tachout circuit to the correct pin inside the ECU by adding one of the optional jumpers on the board (J5). The resistor in the diag port should not be required.
Reply
2
2
Thread Starter
Newb
Joined: Apr 2019
Posts: 8
Total Cats: 2
From: South Jersey
Thank you! That was it. I thought I had done that but I actually only did VTPS enable. You deserve a beer should I ever get the opportunity!
Reply
0
0
Thread
Thread Starter
Forum
Replies
Last Post
