Hi guys. I am just getting my miata up and running again. I installed a 36-2t trigger wheel from supermiata and have trouble setting it up at tunerstudio. In the ignition setting/wheel decoder manual, the miata 36-2t trigger wheel does not show. Do I need to update my firmware?

I have a 95 miata with vvt swap

 

Post a copy of your tune file and a trigger log

 

I hope i'm uploading the right files.

I haven't cranked the car yet so I don't have the trigger log

 

Go to ignition option wheel decoder, then spark mode on the upper left of the box that pops up then you want Miata 36-2 it is the third one from the bottom of the list.

Let us know if it works

 

Just saw your firmware to v3.0.22 or whatever the newest is. i have the v3.0.22 and you should be golden after an update

 

I think my firmware is 1.2.3

Does that make any sense? It's not in the dropdown is because my firmware is too old i think. I tried to use the firmware update on the software but it doesn't let me auto update. It's asking me for a the megasquirt-3 file.

 

what megasquirt are you currently running

 

I have uploaded some screenshots of my version and where I am stuck with the update.

 

running ms3 basic by reverent

 

so first i made a dump and put my tunerstudio version. go to link and download 1.5.0 then once downloaded move it to the desktop and when the box comes up browse to desktop and download. You might not have to move it to the desktop but sometimes my work computer wont let me use files in the download folder

Megasquirt Downloads Firmware and Software - Megasquirt EFI

 

so this happened. trying to figure this out right now.

 

I just ran it with ecu definition from 1.4.0 and it cleared most of the errors away. However I think I do need v1.5.0 from reverent to clear all of the problems. I just send a PM to Dimitris so hopefully I can get a response from him soon

 

The ini file you need is in the firmware zip file you downloaded.

 

good to know. I'll try it again later today

 

This is what I have so far. What did I do wrong?

 

i have followed what you said but there are actually 3 different ecu definitions. Which one am i supposed to use?

 

Use the first ini file the others are for the pro

 

Here's an update. I reloaded to the 1.4.0 firmware with the rev's .ini found here:

https://trackspeedengineering.com/fi...20V3%20140.pdf

This is now the page I'm getting now. Does this look normal?

 

Looks fine. Is the Miata 36-2 trigger wheel option available under the settings I said earlier

 

It is already on 36-2 option already.

Just uploaded the screenshot. I'm still getting the error. Hopefully you guys can help!