Tell me what this means.
Thread Starter
Elite Member
iTrader: (30)
Joined: Aug 2007
Posts: 7,329
Total Cats: 12
From: Va Beach
Tell me what this means.
So I got my car running again today after my map somehow went bad and fried my ignitor. So I went for a short run to datalog so I can run it thru the VE Analyzer. When I did I got this warning.
__________________
Best Car Insurance | Auto Protection Today | FREE Trade-In Quote
__________________
Best Car Insurance | Auto Protection Today | FREE Trade-In Quote
Reply
0
0
Right under the results screen is your Min CLT setting. I believe default is 160. Most likely most of your log is while the car was warming up and so it didn't use the majority of the datalog data.
So its just telling you that it made changes on a small % of the actual log because of the CLT temp filter setup.
So its just telling you that it made changes on a small % of the actual log because of the CLT temp filter setup.
Reply
0
0
Thread Starter
Elite Member
iTrader: (30)
Joined: Aug 2007
Posts: 7,329
Total Cats: 12
From: Va Beach
ahhhh, you know what my car wasnt totally warmed up. SO it isnt anything I should really worry about then? I just need to warm the car up properly and do it again?
__________________
Best Car Insurance | Auto Protection Today | FREE Trade-In Quote
__________________
Best Car Insurance | Auto Protection Today | FREE Trade-In Quote
Reply
0
0
No. You need to just drive more. At least 15 mins through all different loads and speeds.
Reply
0
0
Thread Starter
Elite Member
iTrader: (30)
Joined: Aug 2007
Posts: 7,329
Total Cats: 12
From: Va Beach
Sweet, thanks guys.
__________________
Best Car Insurance | Auto Protection Today | FREE Trade-In Quote
__________________
Best Car Insurance | Auto Protection Today | FREE Trade-In Quote
Reply
0
0
Thread
Thread Starter
Forum
Replies
Last Post
Vashthestampede
Insert BS here
119
Feb 19, 2015 09:42 AM
