Trying to figure out how to program fan control on MSPNP2
#1
Trying to figure out how to program fan control on MSPNP2
So I'm trying to have my condenser fan on when my radiator fan comes on on a 1996 NA. I found that there are separate wires that ground side switch the rad condenser and a/c clutch separately or at least they all have a different pins at the computer.
So the ALED controls the fan temp for the radiator fan but i don't how to setup the control for the condenser fan without hard wiring it? PLZ help...
So the ALED controls the fan temp for the radiator fan but i don't how to setup the control for the condenser fan without hard wiring it? PLZ help...
#7
Thanks I was looking at MSPNP Gen 2 manual not install guide. the WLED still doesn't come on with the other fan with the parameters set the same as ALED and tried it at a lower temp then ALED Still wont come on but is on switched with the a/c clutch So fan control works. Is there a jumper or something that could be wrong?
#8
Update: The control side for the ac/ clutch and condenser fan are connected internal or external of the computer . I believe in the computer because the diagram I have has them separated to the computer. So I think if I connect the rad fan control with condenser fan control wires then it will work as long as i put a diode in between the spice and the Computer. When the rad fan activates it activate the condenser fan relay without turning on the a/c compressor clutch and added bonus when the a/c is activated both fans will run as well because of the the diode direction. What do you guys think?
Thread
Thread Starter
Forum
Replies
Last Post