VE Analyze doesn't correting My VE table, Any thought?

 

did you click send or burn? check that the min temp isn't set too high in advanced settings. Check all filters under advanced settings.

 

Type a few more sentences describing how you're using it. That's my best thought.

 

Yes,I did send and burn.
all my advanced settings are:
Cell change resistance: Normal
Max cell Value change: 50
Max cell percentage change: 50
Filters
Min rpm:0.0 Max: rpm:15000.0
Min fuelload: 0.0 Max fuelload: 400.0
Min CLT: 160.0 Custom Filter: off

Anything I need to adjust?

While I click "Start Auto Tune"
The "Correcting Error" button is flashing on red, but It just doesn't do any correction on my VE table.
The AFR targets table is right too.
And I do see anything under the Status menu. Also Im running the newest version of TS.

 

Did you touch any of the ego correction settings? did you calibrate your wb02? did you disable ego correction?

upload your msq

 

2010-12-12_22.58.49.msq

Thanks many~!

Should I disable Ego correction?

 

You've paid and registered TS, yes? Because I think the live VE autotuning is disabled in the free version.

 

I wasnt able to get it working at first either but I dont know what I did to make it work properly.

In the lower right corner where it says "Active Filter:" is there anything highlighted in yellow?

 

he'd get a webpage on how to buy it if he wasn't registered

 

Is everything setup correctly in the project properties? Did you calibrate WB02?

 

Leave ego correction on. VElive compensates for ego correction while it autotunes.

 

Yes, it not the free version. I paid for it.

 

I registered it. The title is under my name.

 

I will try it tonight.
I do really need to?
because the AFR reading on TS is petty match my independence AFR gauge.

Thx

I will low my CLT to 140.0 to try it out. And do a Datalog first.

 

It's not always necessary

 

for every sentence in a thought

 

to be in a separate post.

 

Do a search for tunerstudio. I believe there is a pretty good writeup to get you up and going.

Edit: https://www.miataturbo.net/megasquirt-18/using-tunerstudioms-tuning-megasquirt-guide-40159/

Look at the stickies in MS forum (where you posted this thread)