VE Analyze doesn't correting My VE table
#4
Yes,I did send and burn.
all my advanced settings are:
Cell change resistance: Normal
Max cell Value change: 50
Max cell percentage change: 50
Filters
Min rpm:0.0 Max: rpm:15000.0
Min fuelload: 0.0 Max fuelload: 400.0
Min CLT: 160.0 Custom Filter: off
Anything I need to adjust?
While I click "Start Auto Tune"
The "Correcting Error" button is flashing on red, but It just doesn't do any correction on my VE table.
The AFR targets table is right too.
And I do see anything under the Status menu. Also Im running the newest version of TS.
all my advanced settings are:
Cell change resistance: Normal
Max cell Value change: 50
Max cell percentage change: 50
Filters
Min rpm:0.0 Max: rpm:15000.0
Min fuelload: 0.0 Max fuelload: 400.0
Min CLT: 160.0 Custom Filter: off
Anything I need to adjust?
While I click "Start Auto Tune"
The "Correcting Error" button is flashing on red, but It just doesn't do any correction on my VE table.
The AFR targets table is right too.
And I do see anything under the Status menu. Also Im running the newest version of TS.
#8
2 Props,3 Dildos,& 1 Cat
iTrader: (8)
Join Date: Jun 2005
Location: Fake Virginia
Posts: 19,338
Total Cats: 573
I wasnt able to get it working at first either but I dont know what I did to make it work properly.
In the lower right corner where it says "Active Filter:" is there anything highlighted in yellow?
In the lower right corner where it says "Active Filter:" is there anything highlighted in yellow?
#18
Edit: https://www.miataturbo.net/megasquirt-18/using-tunerstudioms-tuning-megasquirt-guide-40159/
Look at the stickies in MS forum (where you posted this thread)
Thread
Thread Starter
Forum
Replies
Last Post
Frank_and_Beans
Supercharger Discussion
13
09-12-2016 08:17 PM