Four Rx7 Turbo 550 injectors from a working car $85 shipped within the USA

Pay- Pal accepted

 

Part number? Should be on the side of the injectors.

 

195500-1370

 

Tan top Low Impedence. GLWS

 

Thanks, What does that mean ?

 

It means they are Low Impedence not high Impedence. Good Luck With Sale.
Stock miata injectors are high impedence, as are RX7 injectors part numbers: 195500-1370 and 1350. The ones you have may physically fit a miata, but you will need a low impedence injector driver to run them.

Injector impedance describes the electrical resistance of the solenoid windings. These are usually grouped in two categories:
Low- 1.7 to 3.0 ohms (Peak and Hold Driver/Injectors) High- 10 to 16 ohms (Saturated Circuit Drivers/Injectors)

 

I'm sorry. I know about impedance etc. I meant what does the GLWS meant ?

I was going to drive them with a MS and use a resistor if need be.

Thanks for clarifying for me .

 

where in FL are you located? i might be interested if you have some pictures of them.

 

PM sent

 

quoted for retard of the day.


195500-1370 can come in both high or low...btw fwiw fyi

 

Far as I know it is just a matter of adding the correct resistor.

BTW these come with connectors.

 

do you have them in your hands and do you have a multimeter?

 

F my life. The power of the Brain overcomes me once again.

 

MUHAHAHAHAHAHAHAHA.

The Power of Brain Compels you.

 

You want me to measure DC resistance ?

 

correct.

 

Ok the solenoid resistances average 12.8 ohms ...

 

ok, they are high ohm. everyone can chill the **** out now.

 

Yeah and buy them

Thanks brain

 

pm'd