brake master cylinder brace, bar-less, home brew
Thread Starter
Joined: Sep 2012
Posts: 4,560
Total Cats: 1,143
From: your mom's house phoenix, AZ
brake master cylinder brace, bar-less, home brew
i was making one of these for my 90, and figured i make another while i was at it.
flux cored, 1/8" plate for the horseshoe, 1/4" rod and 1" x 1/8" angle for the upright. 3/8 bolt with 9/16" head, a 14mm should work for those of you that are like me and hate carrying an SAE wrench for an import to the track. painted in high temp glass black engine paint that had a slightly clogged nozzle and resulted and a slightly textured surface.
i have not used mine yet, but appears to be quite stout when i ran the bolt up agaisnt the master.
$40 shipped in US, paypal preferred.
this is mine when i was test fitting, youll receive the black one above
flux cored, 1/8" plate for the horseshoe, 1/4" rod and 1" x 1/8" angle for the upright. 3/8 bolt with 9/16" head, a 14mm should work for those of you that are like me and hate carrying an SAE wrench for an import to the track. painted in high temp glass black engine paint that had a slightly clogged nozzle and resulted and a slightly textured surface.
i have not used mine yet, but appears to be quite stout when i ran the bolt up agaisnt the master.
$40 shipped in US, paypal preferred.
this is mine when i was test fitting, youll receive the black one above
0
Thread
Thread Starter
Forum
Replies
Last Post
Zaphod
MEGAsquirt
47
Oct 26, 2018 11:00 PM
