Built 1.6 part out in Phoenix, Arizona
#1
Built 1.6 part out in Phoenix, Arizona
ello, I am changing directions on my car and parting out my 1.6 engine build. This 1.6 was built and swapped into my FC3S RX7. Most parts were purchased new and have approximately 15 minutes of run time from remote tune with Mark Panic. Most parts are like new, but not brand new. Expect scratches/handling from test fit/install/removal. All polished parts could benefit from a reshine.
Intake package $300
-All transactions will be through PayPal unless local. Buyer is to cover the cost of Goods and Services, packaging, and shipping. Local pickup is available in Phoenix, Arizona.
-Additional pictures can be sent/posted as requested. I have hundreds of photos and can provide more detailed photos prior to shipment.
-Contact: this forum board or PM. Phone/facetime numbers will be discussed through PM due to scammers.
This post is also cross posted on facebook.
Enough words, picture time.
- R8 coilpack swap DIY. G19 1.6 coilpack plate, 3 coilpacks and harness. (plate modified slightly to fit 323 valve cover. 4 coilpacks included, but one has a chip where the connector goes, this one is freebie.) $200
- LS coil pack swap DIY. 8 LS coilpacks, DIY spark plug wires, spark plug wire crimpers, and harness. (spark plug wire parts are Magnecor and MSD parts. Wires, terminals, boots, and grease included.) $200
- AEM SR20 24 tooth CAS trigger wheel (new in package).$30
- ARP headstuds $80
- Injector dynamics ID1000 with new orings, terminals, and connectors (cleaned and flow tested by AUS injection [these are older injectors and tested as 890's after cleaning)$300
- FC3S 1.6 engine conversion mounts $100
- Adamat Perfomance ZF 5 speed S5D-320Z conversion kit. Includes engine to transmission adapter plate, flywheel, twin disc, pressure plate, and hardware. (Clutch plates have hot spotting from drifting, but did not have clutch issues. Priced accordingly incase you want to refresh the clutch kit. Adamat sells all replacement parts.) $600
Intake package $300
- NB 1.6 intake manifold (polished)
- NB 1.6 intake brace (chrome powdercoat)
- Skunk 2 throttle body (started to polish, but coating needs to be stripped prior to polishing)
- OEM Miata TPS
- DIY rough draft of a throttle cable bracket (for FC3S cable, not sure if Miata cable is the same positioning)
- Vibrant NPT plugs/fittings.
-All transactions will be through PayPal unless local. Buyer is to cover the cost of Goods and Services, packaging, and shipping. Local pickup is available in Phoenix, Arizona.
-Additional pictures can be sent/posted as requested. I have hundreds of photos and can provide more detailed photos prior to shipment.
-Contact: this forum board or PM. Phone/facetime numbers will be discussed through PM due to scammers.
This post is also cross posted on facebook.
Enough words, picture time.
Last edited by Azkid; 05-07-2024 at 10:23 AM.
Thread
Thread Starter
Forum
Replies
Last Post