Built 1.8L VVT motor
#1
Built 1.8L VVT motor
Fresh motor built by Mike Haag, formerly of Rebello Racing (head engine builder). He has built some of the National winning Spec Miata motors. Motor has dyno time only, and will be shipped from Haag Performance who has just done a full head off inspection. It was built for turbo and made 300whp at 12psi on a Mitsubishi EVO X turbo. Motor is at Haag Performance in Lodi, Ca, Will ship Nationwide. Pickup also available. Car was sold and parted out.
Hand-ported VVT cylinder head - VVT cam set to output 1 pulse per rev (compatible with Megaquirt, AEM Infinity, etc...) - (Make sure it works for whatever ECU you are using.)
Dual AN fittings on powdercoated valve cover
Supertech SUB lifters
Supertech valve springs/retainers T
omei Cams
Boundary Stage 2 Oil Pump
Flat Top Intake Manifold (also powdercoated same Orange)
Supertech Rods Supertech 8.5:1 Pistons (motor is roughly 9:1 due to head shave)
ARP Head & Main studs
ACL race bearings
Race Oil pan
Does not include SuperMiata Damper in picture
Receipt for 8K not including the head which was I supplied. (I supplied complete head that needed refresh from the previous build & oil pump, everything else is new). Haag refreshed the head and pump, and built all new bottom end. $5500
Thread
Thread Starter
Forum
Replies
Last Post
Savington
Miata parts for sale/trade
2
07-20-2019 10:56 PM