99 Miata Ported&Polish head with ported Intake manifold
09-19-2012, 09:28 PM
#1
Newb
Thread Starter
Join Date: Feb 2012
Posts: 30
Total Cats: -1
99 Miata Ported&Polish head with ported Intake manifold
99 Miata head completely rebuild valve job,shaved,New valve steams, ported and polished, with ported intake manifold and valve cover. Never got to use it need to sell. Ready to install!! Asking 600. I am Located in Miami,FL. I can ship just send me your zip code for shipping price. 786-517-7328 (Carlos) also 4 new Denso 1000cc injectors for sale 255.00 shipped. also have a stock Bottom end (Short block) with 50,000 miles for sale.
Last edited by ramos157; 09-19-2012 at 10:47 PM.
Reply
0
0
09-20-2012, 10:09 AM
#6
Do you have flow sheet before/after?
What is the name of the ACTUAL shop? Can they provide info/receipts?
When you're an unknown noob selling a $600 head you better try harder than his half assed thread or you'll need a LOT of luck and a pretty foolish buyer to make a sale.
Good luck either way.
What is the name of the ACTUAL shop? Can they provide info/receipts?
When you're an unknown noob selling a $600 head you better try harder than his half assed thread or you'll need a LOT of luck and a pretty foolish buyer to make a sale.
Good luck either way.
Reply
0
0
09-20-2012, 10:18 AM
#8
It needs a paper scroll to finish it. It is not much better than the stock casting flash. Maybe worse
It would not take that much work to smooth it better. Not criticizing, it is just not a high dollar port job. As long as the material was removed properly, it is probably not a bad deal.
If a hack started grinding in the wrong place, it is a boat anchor. The rough finish makes it suspiscious.
It would not take that much work to smooth it better. Not criticizing, it is just not a high dollar port job. As long as the material was removed properly, it is probably not a bad deal.
If a hack started grinding in the wrong place, it is a boat anchor. The rough finish makes it suspiscious.
Reply
0
0
09-20-2012, 10:22 AM
#9
Newb
Thread Starter
Join Date: Feb 2012
Posts: 30
Total Cats: -1
I had the flow sheet, I had the work done about two years ago, it's been seating in my garage wrap in black plastic bag ever since. But it did flow a lot more then stock.
Last edited by ramos157; 09-20-2012 at 10:32 AM.
Reply
0
0
09-20-2012, 12:03 PM
#10
Newb
Thread Starter
Join Date: Feb 2012
Posts: 30
Total Cats: -1
Name of the machine shop is brad's Performance. He does all the machine work at my brother inlaw shop. and also the speed shops around hear. I've personally seen on the dyno a 700hp Evo,900hp Mustang and my best friend 580hp sr20 build by him.
Reply
0
0
Thread
Thread Starter
Forum
Replies
Last Post
elesjuan
Build Threads
9
11-14-2018 12:18 PM
