FlyinMiata Complete Turbo Kit with GT2560
#1
Senior Member
Thread Starter
iTrader: (8)
Join Date: Jan 2012
Location: Azusa, CA
Posts: 1,407
Total Cats: 116
FlyinMiata Complete Turbo Kit with GT2560
Selling my Flying Miata 1.8L GT2560 turbo kit. I've upgraded many items for reliability (inconel m10 studs, braided water lines, extra heat shields, etc.) And have installed instrumentation sensors if you're into that sort of thing. Kit is pretty much 100% complete and just came off my car. I've had this on the track a couple times and never had an issue with the turbo system.
$2300 picked up
$2400 shipped to continental US.
Will not split kit.
Complete Flyin Miata Turbo Kit
-Garett GT2560 Turbo
-Trackspeed Inconel Stud Kit upgrade m10x1.5 ($130 upgrade)
-Intercooler with Silicone Piping (I've added additional compressor out pressure and temp sensors. You can hook them up or just leave them unconnected)
-Flyin Miata exhaust manifold. Hand ported to improve flow and wastegate bypass. EGT thermocouple and Exhaust back pressure sensor included
- 10 an drain line Upgrade
-upgraded braided stainless AN water feed lines
-Flyinmiata heat shield
-2.5" downpipe with extra custom heat shielding
-7 psi garett wastegate
-Bosch Recirc BOV with plumbing
-Go Fast Bits vent to atmosphere BOV if you're into that sort of thing.
-Oil feed tee and braided stainless line with oil pressure sensor tee'd in
-two DIY catch cans
-two gauge A-pillar mount already drilled with boost gauge
$2300 picked up
$2400 shipped to continental US.
Will not split kit.
Complete Flyin Miata Turbo Kit
-Garett GT2560 Turbo
-Trackspeed Inconel Stud Kit upgrade m10x1.5 ($130 upgrade)
-Intercooler with Silicone Piping (I've added additional compressor out pressure and temp sensors. You can hook them up or just leave them unconnected)
-Flyin Miata exhaust manifold. Hand ported to improve flow and wastegate bypass. EGT thermocouple and Exhaust back pressure sensor included
- 10 an drain line Upgrade
-upgraded braided stainless AN water feed lines
-Flyinmiata heat shield
-2.5" downpipe with extra custom heat shielding
-7 psi garett wastegate
-Bosch Recirc BOV with plumbing
-Go Fast Bits vent to atmosphere BOV if you're into that sort of thing.
-Oil feed tee and braided stainless line with oil pressure sensor tee'd in
-two DIY catch cans
-two gauge A-pillar mount already drilled with boost gauge
Last edited by cyotani; 01-13-2019 at 04:48 PM.
Thread
Thread Starter
Forum
Replies
Last Post