FM Built 1.6L
#1
Junior Member
Thread Starter
iTrader: (3)
Join Date: Sep 2010
Location: Austin
Posts: 217
Total Cats: -1
FM Built 1.6L
Show everyone your bigger ***** for using a 1.6L instead of a 1.8L
figured I'd post it up here just in case there's someone
who wants to pursue a 1.6L build.
Engine - $2500 obo
(Build was upwards of $6000 - receipt I will provide does not reflect the Pauter rods and ARP studs as they were provided by the customer, previous owner put 2k on it, I put 6k on it with no issues until the belt slipped. needs timing to be reset and was going to do a new belt - but I have to move!)
*Fully handbuilt motor by Flying Miata (complete with plaque on the valve cover)
*Wiseco forged Pistons 9:1, 1mm overbore
*Pauter forged rods
*HKS 264 cams, 9.5 lift / 9.3 lift
*ARP Main cap studs
*Flyin Miata Adjustable cam gears
*Port and polished cylinder head
*Flyin Miata Upgraded valves springs with titanium retainers
*Multi-angle valve job, port and polish, port-match intake, unshroud valves,
*+1 intake and exhaust valves, unshroud chamber lip, polish combustion chamber,
*Unshrouded valves
*Polished valve cover
I have a boundary engineering street pump and ati damper that I could sell you also that you could put on when you do the belt.
Located in Ann Arbor, MI
Engine is still in the car, I would need some time to pull it.
figured I'd post it up here just in case there's someone
who wants to pursue a 1.6L build.
Engine - $2500 obo
(Build was upwards of $6000 - receipt I will provide does not reflect the Pauter rods and ARP studs as they were provided by the customer, previous owner put 2k on it, I put 6k on it with no issues until the belt slipped. needs timing to be reset and was going to do a new belt - but I have to move!)
*Fully handbuilt motor by Flying Miata (complete with plaque on the valve cover)
*Wiseco forged Pistons 9:1, 1mm overbore
*Pauter forged rods
*HKS 264 cams, 9.5 lift / 9.3 lift
*ARP Main cap studs
*Flyin Miata Adjustable cam gears
*Port and polished cylinder head
*Flyin Miata Upgraded valves springs with titanium retainers
*Multi-angle valve job, port and polish, port-match intake, unshroud valves,
*+1 intake and exhaust valves, unshroud chamber lip, polish combustion chamber,
*Unshrouded valves
*Polished valve cover
I have a boundary engineering street pump and ati damper that I could sell you also that you could put on when you do the belt.
Located in Ann Arbor, MI
Engine is still in the car, I would need some time to pull it.
Thread
Thread Starter
Forum
Replies
Last Post
_spyder
Engine Performance
4
08-06-2012 07:16 PM
Frank_and_Beans
Engine Performance
19
07-17-2012 10:26 PM